Optimization Milling Force and Surface Roughness of Ti-6Al-4V Based on Ultrasonic-Assisted Milling (UAM): An Experimental Study.

Micromachines (Basel) · 2023 · PMC10537650 · PMID 37763862

Europe PMC DOI

hedged sentence

—

closest p

—

boldest claim

The sentences

a decreasing trendno p-value reported

As shown in Figure 6 , the milling forces F x and F z showed a decreasing trend with the increase in ultrasonic amplitude, but when the amplitude is 1, the cutting force of UAM is slightly larger than that of CM, indicating that a smaller amplitude is not positive for reducing the cutting force.

also in 47,180 other papers

Quoted from the open-access full text in Europe PMC under the licence the publisher applied. The sentence is reproduced exactly as published; the emphasis is ours.