Comparative Analysis of AWJM Performance in FFF-Printed PLA and PLA-CF: Influence of Process Parameters and Cutting Regions.

Polymers (Basel) · 2026 · PMC13211052 · PMID 42198151

Europe PMC DOI

hedged sentences

—

closest p

—

boldest claim

The sentences

an increasing trendno p-value reported

Influence of Water Pressure (WP) When water pressure (WP) is kept constant, kerf taper generally shows an increasing trend with increasing traverse feed rate (TFR), especially in PLA-CF ( Figure 13 ).

also in 63,971 other papers

highly significantno p-value reported

The material factor exhibits a highly significant effect on roughness, confirming that PLA and PLA-CF cannot be considered equivalent from the standpoint of surface finish ( Table 6 ).

also in 132,142 other papers

Quoted from the open-access full text in Europe PMC under the licence the publisher applied. The sentence is reproduced exactly as published; the emphasis is ours.