“a decreasing trend”

Among these, 19 metabolites, mainly lipids and lipid-like molecules, show a decreasing trend over time, possibly due to microbial degradation.

Poly(I:C)-induced microglia activation, which might release proinflammatory factors, showed a decreasing trend in BV2 cells with the inhibition of CTSB activity by inhibitor CA-074 after 24 h, and the initial phases of activation-induced microglia death could indicate active functions for cathepsin X [ 67 ].

The apparent porosity of castables with only added AEA and alumina bubbles after being dried at 110 °C and treated at 1300 °C presented a decreasing trend as CAC content increased.

The increase in screening time leads to an increase in the median particle size, and the proportion of finer particles presents a decreasing trend.

Stress within the root dentin showed a decreasing trend from stage S1 to stage S5 in most models at both levels.

As the number of FTs increases, the bending load-deflection curve shows a decreasing trend, but the peak load reduction is less significant compared to the TS.

The test results showed that the density of the specimens showed a decreasing trend with the decrease in the interface temperature, but the porosity was always below the 3% threshold specified in the standard.

For both curves, there is a decreasing trend when the LOA length exceeds 1 cm, and the decreasing rates of the snoring rate curve for the male subgroup are slightly greater than those for the female subgroup.

In most studies, the incidence of AMI and mortality from IHD have been on a decreasing trend, and, in particular, in-hospital mortality from AMI has been decreasing in some European countries [ 18 , 19 ].

With the increase in temperature, the number of hydrogen bonds in each system showed a decreasing trend in general, which was mainly considered to indicate that the molecular thermal motion was intensified after the energy of the system was increased, making it difficult to maintain a stable hydrogen bonding network, and the hydrogen bond energy was low, making it easy to be destabilized at high temperatures.

The results show that the adsorption capacity increases with the increase in the initial concentration of fluoride until it reaches an equilibrium adsorption capacity of 263.33 mg g −1 , whereas the removal rate shows a decreasing trend from 88.78% to 32.92%.

However, after the cultivation of Morchella sextelata , microbial diversity showed a decreasing trend despite the increase in the relative abundance of fungal communities in the soil, which may be a potential reason for the decrease in yield when morel mushrooms are cropped in a continuous crop.

When plants were subjected to high-temperature stress at 40 °C, the net photosynthetic rate showed a significant increase compared to the control group at 22 °C, but in a 45 °C stress environment, the Pn showed a decreasing trend.

The Contents of 2′-O-Methylation Modification (Nm) Showed a Decreasing Trend During the Germination Process The methylation modifications of Nm (including Am, Cm, Gm, and Um) all occur at the 2′ position of the ribose of their respective nucleosides.

Within the range of S/B from 0.8 to 1.4, the enhancement effect of the S/B ratio on the early strength (7-day) showed a decreasing trend, while the improvement in the later strength (28-day) was most significant when S/B was between 1.0 and 1.2.

In addition, there was a decreasing trend in platelet diameter after three months of probiotic administration compared to the corresponding control (T0), but this did not reach a statistical difference ( Figure 4 C). 3.2.

Concrete Deterioration Damage Under Freeze-Thaw Cycles-Loaded-Landfill Leachate Coupling Under freeze-thaw cycles, 40% loading, and landfill leachate coupling, the concrete mass showed a decreasing trend with an endpoint mass loss of 3.35% ( Figure 6 a), which was substantially higher than that of the landfill leachate group (0.54%) and the 40% loading and landfill leachate coupling group (0.72%).

The measured surface microhardness values for these four samples are 192.4 ± 6.9 HV, 182.3 ± 2.8 HV, 178.9 ± 2.9 HV, and 166.9 ± 0.3 HV, respectively, indicating a decreasing trend in microhardness.

All compositions exhibited a decreasing trend in the relative viscosity as a function of the shear rate, confirming their pseudoplastic (shear-thinning) behavior; all the systems represent non-Newtonian fluids (the viscosity decreases with an increasing shear stress value) [ 37 ].

Following primary forming at 500 °C and subsequent annealing, density exhibited a decreasing trend with increasing silicon content, as illustrated in Figure 7 .

With prolonged heat treatment, the coercivity and maximum magnetic energy products of the ribbons exhibit a decreasing trend.

These genera showed a decreasing trend in the preventive group administered with XSO ( Figure 8 A).

As can be seen in Figure 7 , the peak shear strength exhibits a decreasing trend with increasing filling degree.

Furthermore, with the increase in nitrogen doping concentration, the cell parameters exhibited a decreasing trend.

The impact of t 1 on the total effective band gap width is depicted in Figure 10 f, showing a decreasing trend as t 1 increases.