Excerpts

The analysis in Figure 1 b shows that with the increase in the hydrochloric acid concentration, the n(Si/Al) of the acid leaching sample showed a trend of first increasing and then stabilizing.

As highlighted in Figure 3 , the outputs related to the analysis with lower DAF, in general, show an increasing trend of peak forces when increasing the geometry porosity.

Furthermore, the yield displacement and the load exhibit a decreasing trend with the subsequent increase in ( n ).

As seen in Figure 12 d, a clear trend is presented: The greater the amount of extract used in the biosynthesis of ZnO NPs, the greater its photocatalytic activity.

However, since the decreasing rate of solid solution strengthening was smaller than the increasing rate of dispersion strengthening, alloy still showed an increasing trend in the range of 5–100 h.

Figure 3 b shows that both the recovery of scheelite and calcite showed an increasing trend as the pH increased from 6 to 12.

Therefore, addressing the issue of multiple explosion suppression and attaining consistent and dependable suppression during numerous explosions is practically significant for the underground safety of coal mines.

Uncertainty Analysis There may be significant uncertainties in the gas concentration, volume, detonation point, explosion distance, and explosion shock wave propagation process in actual explosion scenarios, resulting in discrepancies between actual explosions and experiments, empirical formulas, and numerical simulations.

The trend of the FLC on the left and right sides of the four DP steel is the same, showing a decreasing trend in the left branch as a whole, and an increasing trend in the right branch. 3.3.

After experiencing WD-FT coupled cycling, the average abundance showed a trend of slight fluctuation followed by a gradual decrease, indicating that the WD-FT coupled cycling promoted the roundness of the internal particles of the soil ( Figure 10 b).

Compared with samples in the initial state, the samples experiencing WD-FT coupled cycling showed a decreasing trend in the principal stress difference.

-A tendency for E to increase was observed as the annealing time and temperature increase, while the flexural strength and failure strain had a decreasing trend.

In general, reducing the detection temperature of various gaseous analytes is a clear trend in the industry, as it promotes device miniaturization (which increases device mobility and improves economic aspects) as well as sensor safety.

However, as the modification time increases from 21 to 35 days, the expansion of the concrete shows a decreasing trend.

The slump shows a decreasing trend as SF content increases, which is similar to the conclusion in the literature [ 34 ].

From Figure 8 and Figure 9 , it can be seen that the cohesive energy density and solubility parameters of the matrix bitumen showed a decreasing trend with increasing temperature from 110 °C to 150 °C, while the cohesive energy density and solubility parameters of nano-ZnO particles fluctuated from 110 °C to 140 °C, but the fluctuations were not significant, while after 140 °C, the cohesive energy density and solubility parameters of nano-ZnO particles increased substantially.

Interestingly, a notable trend was observed, where an increase in light transmittance corresponded to a rapid increase in FOM.

A decreasing trend was found in grain size, and the final grain size was less than 1 μm.

[ 24 ], considering 25 air-polishing treatments on bovine high-gloss polished sound enamel, found that the regular use of sodium bicarbonate and erythritol powder during a simulated fixed appliance therapy led to a highly significant increase in surface roughness, in which sodium bicarbonate was significantly more abrasive than erythritol.

Consequently, all four types of asphalt exhibit a decreasing trend in adhesive work.

Additionally, it can be found by analyzing and comparing the data in Figure 4 c and Table 1 that the surface area of rGA-6, rGA-7, rGA-8, and rGA-9 shows an increasing trend from 9.12 m 2 /g to 55.14 m 2 /g and at the same time, the average pore size of the samples is decreased from 10.94 μm to 3.22 μm.

The content of the Brass texture component was low at all three locations and showed a decreasing trend from the surface to 1/2 thickness.

However, for the entire Z p measuring range, the increasing trend, in general, is visible, whereas, for the β(Z p ) relationship ( Figure 6 c), a decreasing trend is visible with some disturbance near the CH level.

A clear trend towards mild substances can be seen, particularly organic acid-based preservatives are quite popular nowadays.

Test probability was considered significant for p < 0.05 and highly significant for p < 0.01. 3.