Excerpts

As the loading rate increases, the bond strength of the specimens shows an increasing trend.

As shown in Figure 6 a, the bubble density generally showed an increasing trend with increasing experimental ambient temperature, especially above 30 °C, where the upward trend became more pronounced, and the bubble density increased significantly.

Concerning the effects of Ba, Ca, and Mg, the intensity of the Ce 3+ luminescence generally exhibited an increasing trend in this type of glass.

Compared to the longitudinal modulus E 11 , the tensile strength X T and compressive strength X C of the C f /SiBCN CMC exhibit more pronounced variations as the size of defect increases, showing a decreasing trend.

As can be seen, the RV s of the smaller particles shows an increasing trend with the increase in the mass percentage.

A clear trend was observed for all tested blend samples.

An increasing trend can be observed as a polynomial function of the nitrogen content of the samples analyzed.

As the plating time increased, the overall coating thickness exhibited an increasing trend.

This contrasts with the highly significant values of “triple bonding” of an increase of 57% for CFRP and an increase of 67% for mild steel.

After long-term aging, the overall density of the LBE samples shows a decreasing trend, the density fluctuation range of the fast cooling rates (5 K/min and 10 K/min) are significantly larger than that of the slow cooling rates.

The lattice strain values also follow a decreasing trend with an increasing CTAB concentration, indicating improved crystallinity.

The flowability of fresh UHPC slurry showed a trend of first increasing and then decreasing with the increase in AS content.

Both shear and tension cracks showed an increasing trend, with the growth rate of tension cracks consistently higher than that of shear cracks.

In this scenario, there was a clear trend of damage propagating both longitudinally and transversely across the track slab, which is shown in Figure 8 b.

At notch depths of 20 mm and 30 mm, with asphalt emulsion content greater than 2.0%, the fracture energy showed a trend of initially decreasing and then increasing with rising temperature.

Consequently, specimens with deeper notch depths exhibited a decreasing trend in fracture energy under low-temperature conditions as asphalt emulsion content increased. 4.2.2.

Based on Figure 9 and Table 2 , it was revealed that the compressive strength and flexural strength of the new fast-curing polymer material sand consolidation exhibited an increasing trend with an increase in mesh number under the conditions of 10–15 mesh, 60–80 mesh, and 325 mesh.

As the heating time increases, the ductility coefficient of the ST-RC columns exhibits a decreasing trend, with a 5.72% reduction observed after 120 min of heating.

On the other hand, changing the GGBS content in the precursor (from B1 to B3) at the same PET powder replacement ratio does not show a clear trend regarding its impact on J IC .

The H c value drops first from 12.27 to 11.55 Oe with increased Fe 2 O 3 contents from 0 to 2 wt% and then follows an increasing trend up to 12.75 Oe with a further increase in Fe 2 O 3 nanopowders.

In contrast to this, the CSF band gap increases slowly by only 4.4%, and this dependence demonstrates a clear trend of slowing down.

As the microcapsule content increased, the friction coefficient showed a decreasing trend.

For the Ra parameter, which represents the arithmetic average of the absolute deviations from the mean line, a decreasing trend with an increased washing time is observed for the Rigid 10K and Tough 2000 materials.

For maintenance periods of 7 and 28 days, E 50 exhibits a decreasing trend with increasing CO 2 foam dosage, peaking at 36% foam doping.

Also, an increasing trend is observed for the melt pool’s width with the VED.