“a decreasing trend”

We found that, in human embryonic cardiomyocytes, their expression presumably undergoes a decreasing trend (CMs-A, S6C top, green curve), or decreases and then increases (CMs-V S6C, bottom, green curve).

When the number of freeze–thaw cycles increases, the hardness of SPI, SG25, and SG30 show a decreasing trend.

While LH did not have a notable impact on serum LDL-C levels, there was still a decreasing trend that could be observed.

On day 14, a decreasing trend in the metabolic activity of cells was observed in the wells where pristine and 4 mg/mL CaO 2 -laden composite hydrogels were present.

Even though a few countries have observed a decreasing trend in suicide mortality, data from most parts of the world show an increasing trend in deaths due to suicide [ 4 ].

The results indicated that the petal elongation rate peaked after treatment with 5 μM GA, and CmGEG expression exhibited a decreasing trend over time, suggesting that CmGEG is negatively regulated by GA ( Figure S3A ).

The results presented in Table 2 show a decreasing trend in metal site density when NiCeZr was doped with various elements.

Furthermore, under the same amount of sugar addition, there was a significant reduction in the content of Olsen inorganic P in HCs when AM fungus was inoculated, as well as a decreasing trend in Olsen organic P ( Figure 2 c,d).

The authors highlighted a decreasing trend in complication incidence over recent years, attributing this to advancements in surgical equipment and techniques.

A decreasing trend in the ratio between these two metrics is observed when the scaling factor increases.

As depicted in Figure 2 a,b, the proportion of Ki67 + AT2 cells exhibited a decreasing trend from 3 m to 12 m.

Over time, the average reflectance at each temperature exhibits a decreasing trend. 3.2.

Early detection of GC and a decreasing trend in H. pylori infection are expected to lead to a further reduction in GC-related mortality in Japan.

In a rat model, the transplantation of kidneys affected by membranous nephropathy demonstrated a gradual reduction in proteinuria, which, although never reaching negative levels, showed a decreasing trend after 2 weeks post-transplantation.

Specifically, the indices CIVE, ExR, R, RGRI, and VARI showed a gradual increase; the indices B, GCC, GRVI, NGRVI, PPR, and WI showed irregularities; and the remaining indices showed a decreasing trend.

However, another study on the effect of iron on the fatty acid composition of Tropidoneis maxima [ 36 ] showed a decreasing trend for EPA, DHA, and PUFA in T. maxima and the influence of high concentrations of FeSO 4 (1 mg L −1 ).

However, a decreasing trend in the mean pruritus-related score on the SCORAD scale was observed in patients with baseline pruritus-related values over five up to week 20 of treatment.

Overall, whether the change in aHR assessed in terms of cumulative dose or duration of exposure to spironolactone, we observed a decreasing trend in prostate cancer risk and an increasing trend in renal cancer risk.

The loss of the Fe-Co alloy in the face of compressive stress shows a decreasing trend [ 27 ].

These differences exhibited a decreasing trend, indicating that higher inoculation solution concentrations lead to greater spore yields.

In both sexes, a decreasing trend with age was observed.

It can be observed that as the deviation angle increases, both the ultimate tensile strength and yield strength show a decreasing trend, while the elongation and cross-sectional shrinkage exhibit an increasing trend.

It can be seen that although the splitting tensile strength of the asphalt mixtures showed a decreasing trend with the increase of dynamic water pressure, there were significant differences in the strength variation characteristics of the three asphalt mixtures.

Generally, SEA shows a decreasing trend with the variation in cross-sectional width, while the change in trend of ICF is opposite to that of SEA , which should be the result of the increasing influence of the multicellular tube’s mass on the optimization of larger cross-sectional width conditions.

It can be seen that at the annealing time of 30 s, the microhardness value is in a decreasing trend with the increase of annealing temperature.