Excerpts

The percentage of R 2 was 96.08%, which reflects the highly significant effect of these factors on the compressive strength of B-FCB.

The D 10 , D 50 , and D 90 values for the individual genesis powders (i.e., G 1 , G 2 , G 3 ) show an increasing trend ( Figure 3 ).

In general, there was not much difference in terms of pressure loss between the four knitted structures after 5 washes, but this difference was quite significant after 10 and 15 washes, which suggests that the knitted stretchable fabrics tend to lose their compression ability after multiple washes.

Figure 4 b compares the variation of d e,f against d max , indicating a decreasing trend of elastic displacement fraction with increasing maximum indentation displacement for both indentation cycles, and the corresponding ranges of values can be observed.

Even though the two parameters are alike, Figure 3 demonstrates an interesting trend between MAC and energy.

Meanwhile, the retentivity ( M R ) of both aged SR-MRE samples demonstrated an increasing trend after the thermal aging procedure indicating that the magnetic isotropy strength has increased with the influence of heat.

It can be seen that there was an interesting trend in fatigue life.

We see a clear trend from the results.

It should be emphasized that the accuracy of the tensile behavior predictions in this study are highly significant, because the results could be employed for evaluating the ductile fracture of materials during actual metal forming.

Figure 2 a,b indicates an increasing trend in slump flow from the initial moment until 10 min after the beginning of the first mixing, but Figure 2 c depicts the slump loss at the fiftieth minute.

Furthermore, although the D was not a significant factor in the tensile strength degradation of the BFRP, it was somewhat significant in the case of the GFRP.

At present, there has been an increasing trend for biomimetic nano-HA to be used as a preventative agent for oral care products [ 17 ].

Although in this case the use of the HiPIMS coating did not produce a significantly better machined surface quality, when compared to the dc MS-obtained coated tool, the increase in wear resistance is quite significant.

From the figures, the modulus and strength properties all exhibited a decreasing trend as the void content increased.

Similarly, the F40 series specimens exhibited a decreasing trend in slump values, varying from 195 mm to 160 mm.

It can be found that with the increase of the Ce element, the content of pearlite shows an increasing trend, and the content of ferrite shows a decreasing trend.

Looking at the standard deviation of the measurements, it seems that the average height was similar in different areas of the samples; nevertheless, there are quite significant differences in the values of maximum height.

However, the ductility of W-Mo-Ni-Fe alloys was higher than that of the W-Ni-Fe alloy, and a decreasing trend was observed with an increase in molybdenum percentage.

It shows that the mass prediction model has an obvious trend of change.

Through the mass nondestructive testing and ultrasonic nondestructive testing of concrete specimens, we found that, with the increase in dry–wet cycles, the mass loss rate of the specimen showed a trend of decreasing slowly and then increasing rapidly after leveling off.

Bulk densities of the glass-ceramics show an increasing trend with increasing CTZ content.

[ 25 ] even show a decreasing trend when R ≥ 2.0 mm (see Figure 3 a).

From Figure 3 a, the impervious performance of the sample showed a trend of rising firstly, and then failing with the increase in coating material content: When there was no film coating, the hydrostatic pressure resistance height of the sample was 0 mm.

The frequency of treatment application shows a decreasing trend, in which the higher the frequency, the higher the mean SR.

The results indicate that the effect of the independent variable or treatment effect (time) is highly significant.