“a decreasing trend”

molitor , Firmicutes increase progressively from Control and Mixed diets to PU and Starved diets, whereas Proteobacteria show a decreasing trend along the same gradient.

Compared with CK, the abundance of Proteobacteria in RF and BDF1 treatments increased by 7.66% and 4.12%, respectively, while that in BDF2 treatment decreased by 0.03%; the abundance of Acidobacteriota in all film mulching treatments showed a decreasing trend.

Furthermore, Proteobacteria , Rokubacteria , Planctomycetes , Bacteroidetes , and Latescibacteria exhibited a decreasing trend in both air-dried and rewetted soils.

The expression level of COX-2 tended to be higher in groups C and L than in group B, whereas groups M and H exhibited a decreasing trend in COX-2 expression compared to group C ( Figure 10 ). 3.9.

A decreasing trend in relative uncertainty was observed with increasing absorbed dose.

TPC and T-AsA content were highest in RB (31,600 ± 560 mg MR eq./100 g DW and 51.2 ± 0.6 mg/100 g DW, respectively), followed by NL and OL, showing a decreasing trend with leaf maturation.

Overall, the entire 0–28 d trial period, the overall trends differed among groups: a decreasing trend was observed in the medium-dose group, while an increasing trend was noted in the low- and high-dose groups.

Notably, the polarization voltage (ΔE), calculated at a capacity of 70 mAh g −1 , showed a decreasing trend upon cycling: 0.245 V (1st cycle) → 0.266 V (100th cycle) → 0.214 V (200th cycle) → 0.180 V (300th cycle).

Consequently, both PI and PI-MoS 2 exhibited a decreasing trend in friction coefficients as the temperature increased. 3.2.

It can be observed that the fitting accuracy exhibits a decreasing trend as the loading rate increases.

With the gradually increasing phenolic resin content, both the aerogel particle size and pore volume exhibit a decreasing trend.

Figure 9 b shows that under indoor UV aging, the retention rates of both tensile strength at break and elongation at break for the GM specimens generally exhibited a decreasing trend with increasing aging time.

A decreasing trend with increasing storage duration was observed for contents of benzyl acetate, p-cresyl methyl ether, methyl benzoate, prenyl acetate and 3-methyl-3-butene-1-ol acetate ( Table 2 ).

From a spatial perspective, PFAS concentrations in the urban runoff exhibited a decreasing trend from the wastewater treatment plant discharge point toward downstream sections as the distance from sewage sources increased.

By day 7, the wound area of each group showed a decreasing trend, indicating progression into the proliferative phase of healing.

As we can see, the scores of sensory attributes in all the evaluated samples showed a decreasing trend.

In both groups, a decreasing trend in angles was observed in each direction after training.

Previous prospective surveillance studies have also demonstrated a decreasing trend in adverse event incidence across IPV doses, with the first dose exhibiting the highest rate and subsequent doses showing lower rates, a pattern attributed to increased tolerability following initial exposure [ 33 ].

As the distance increases, all methods exhibit a decreasing trend due to SNR degradation.

If anything, the AA content shows a decreasing trend with an increase in the PEF content.

Joinpoint regression analysis supported an overall increasing trend in the incidence rate (AAPC 2012–2025 = 3.89%) and a decreasing trend in mortality (AAPC 2012–2025 = −12.10%) ( Table S1 ).

It can be observed that as the epoxy content increases, the tensile strength of the materials exhibits a decreasing trend, while the elongation at break shows a gradual increase.

All laboratory parameters showed a decreasing trend during the patients’ disease course.

Following an initial increase from the pre-experimental soil pH at day 5, all treatments except BC exhibited a decreasing trend until saline water irrigation at day 20 ( Figure 3 ).

From Figure 1 d–f, the tensile index, burst index, and tear index of the paper all show a decreasing trend because the fibers are partially damaged during the lignin removal process, resulting in a decrease in the intrinsic strength of the fibers.