Barely Significant
← all phrases

“a decreasing trend”

47,181 sentences · 47,181 papers · 78,848 search hits before verification · confirmed specimen

Sighted at

p=0.09

Listed by Hankins (2013) · Otte et al. (2022)

In the literature

However, at higher AS-GO loading (0.5 wt%), a decreasing trend in toughness of cured resin systems is reflected in relatively few stripes, a smoother surface and strip chasm being observed, which can be attributed to a higher proportion of unreacted AS-GO accumulation agglomeration (as indicated by the red arrows in Fig. 12d ) has an adverse effect on toughness.
A decreasing trend in Alb after AIS was also reported by Makris et al. 29 Previous literatures suggested that lower serum Alb level was associated with worse neurological state and poor function outcomes in all the AIS subtypes classified based on TOAST 30 , 31 and higher odds of hemorrhagic transformation post-AIS.
Plant coverage decreases, which leads to an increase in soil bulk density and a decrease in soil structure stability, the soil clay content shows a decreasing trend, soil wind erosion increases, the amount of soil clay particles blown away by the wind increases, and the soil water and fertilizer conservation capacity decreases, resulting in soil degradation.
The tumor volume of the mice treated with the CuS@MnO 2 NPs or CuS@MnO 2 –RGD NPs under 1064 nm laser irradiation were obviously suppressed and appeared to show a decreasing trend, and the curative effect of the CuS@MnO 2 –RGD NPs was slightly better than that of the CuS@MnO 2 NPs owing to the great enrichment of the CuS NPs in the tumors.
29,30 The initial discharge capacities of LMOA, LMOB, LMOC and LMOD were 109 mA h g −1 , 106 mA h g −1 , 102 mA h g −1 and 102 mA h g −1 , respectively, showing a decreasing trend with increasing coating content due to the inactive nature of these coatings toward Li + ions. 6 LiMn 2 O 4 → Li 1− x Mn 2 O 4 + x Li + x e − , ( x < 0.5) 7 Li 1− x Mn 2 O 4 → Mn 2 O 4 + (1 − x )Li + (1 − x )e − , ( x ≥ 0.5) Fig. 5 shows the cycling stability of all samples at a current density of 1.0C between 3.0 and 4.2 V at 25 °C and 55 °C.