The interface strength was strong at 5 min, and from this delay time, there was a decreasing trend between specimens deposited at 10 and 15 min, where a small fluctuation was measured ( Figure 8 ).
Excerpts
a positive trendgold
A positive trend observed in the national materials economy over recent years is the greater importance of secondary raw materials and recycled materials.
The domestic consumption of raw materials reveals an increasing trend, whose dynamics vary depending on the material group.
The further rise in M resulted in a decreasing trend of the P curve.
T curve ( Figure 9 a) even before turning the decreasing trend of E’ into an increasing trend.
As shown in Figure 11 , under each impact pressure, the temperature damage residual factors of specimens treated after distinct high temperatures were all smaller than those at room temperature, and the temperature damage residual factors showed a decreasing trend with the rise of temperature.
However, by decreasing the value of Z, the recrystallized fraction decreases first, followed by an increasing trend, and finally decreases again.
Moreover, an interesting trend is presented in Figure 1 f.
Sample B showed a decreasing trend for the SAC value, from off-state at 0.676 to on-state (1) at 0.569 and on-state (2) at 0.572.
It can be seen from Table 4 that the elasticity modulus of concrete with strength grades C15, C20, and C30 all showed an increasing trend with an increase in water saturation.
The results showed a trend of gradually decreasing first, then increasing, and finally decreasing rapidly.
In addition, the fracture toughness exhibits an increasing trend as the volume fraction of equiaxial α phases decreases.
The amount of sizing on the fibre surface correlated with the composite tensile properties in the case of PP showing initially an increasing trend in strength and modulus with increasing amount of sizing but at higher concentrations again a drop in the performance.
The deformation required for adequate bonding was slightly significant, but it can be reduced by increasing the temperature during the rolling process.
It can become somewhat significant when the change of strain, shape, and damage are not subjected to control by the external or internal applied force on pipelines.
The relative compressive strength calculated as the ratio of the compressive strength value of experimental specimens BM1–BM3 and the reference sample ( Table 15 ), showed an increasing trend of 14–23% 56 days.
There has been an increasing trend in the usage of industrial as well as agricultural waste products as dispersed phase.
In the case of the kerosene dielectric, a decreasing trend of MRR is observed for a pulse–time ratio from 0.5 to 1.5, as presented in Figure 6 d.
A decreasing trend of the large capillary pores of the hardened slurry can be observed when more CNS particles and SS were incorporated.
Fly ash is the main component of the solid waste discharged from thermal power plants, and fly ash output has shown an increasing trend in China.
Pastes with GP (G-20, G-30 and G-40) show a decreasing trend in CH with increase of cement replacement by GP (about 21%, 17% and 14%, respectively).
An increase in the X-ray energy causes a decreasing trend in GSI values [ 15 , 16 ]; at the same time, considering Equation (10), when GSI values tend to decrease, the mass attenuation coefficient should decrease in a proportional way.
The Gd 5 Ge 2 Si 2 alloy and pure Gd showed a trend of development of MCMs.
The assessment of the experimentally obtained results in accordance with the EC2 and the MC2010 has led to the following conclusions: (1) The accumulated shrinkage strain during 5.3 years was quite significant and capable of making serious impact on the load–deformative behavior of the member as well as on their tension stiffening behaviors; (2) The shrinkage effect lowered the apparent RC member cracking load.
For specimen A-24h, very low R p values are recorded, below 10 kΩ∙cm 2 , with an increasing trend toward 30–40 kΩ∙cm 2 between 14d and 141d.