Excerpts

Furthermore, although the D was not a significant factor in the tensile strength degradation of the BFRP, it was somewhat significant in the case of the GFRP.

At present, there has been an increasing trend for biomimetic nano-HA to be used as a preventative agent for oral care products [ 17 ].

As can be seen from Figure 18 and Figure 19 , when the consolidation pressure increases, the consolidation coefficient of CRFS shows an increasing trend.

However, with an increase in tempering temperature from 630 to 670 °C, the diffusion of carbon in martensite leads to the decrease in carbon content in martensite; as a result, the tensile strength and yield strength show a decreasing trend.

According to the calculations in Table 2 , the residual stresses in the nickel plating show an increasing trend as the texture coefficients of the crystal plane (111) increases.

The results of the preliminary research by the authors suggest that the thermal effect of this process on the material cut may be significant.

They distinctly identified the need to fabricate high-performance hybrid aluminium composites and reported that the mechanical properties particularly the tensile strength improves up to a certain extent, i.e., 3 to 5 wt.% of SiC; however, beyond this range, the tensile strength showed a decreasing trend.

Our study found no significant change but a slight trend of reduction on the hindfoot eversion and forefoot abduction.

It can be found that with the increase of the Ce element, the content of pearlite shows an increasing trend, and the content of ferrite shows a decreasing trend.

[ 11 ], the impact of desert sand replacement rate on the compressive strength of high-strength concrete showed a trend of first increasing and then decreasing.

Carbon and glass fibre metal laminates present an increasing trend of the force as the impact develops, the trend continues up to a maximum value, where the force start to decrease.

The analysis of the coefficient d f / d t , which describes the laminate capacity to accumulate energy through the elastic deformation with correlation to permanent deformation [ 43 ] was presented in Figure 5 , it can be observed a positive trend with the impact energy.

Furthermore, a decreasing trend in the maximum force in the fibres can be observed with an increasing number of cycles due to relaxation phenomena in the fibre–matrix interface or the fibre itself.

Deviations of the slope of the measured and simulated force-displacement relationships becomes moderately significant when the head displacement reaches approximately 0.11 mm.

The CoFe (110) peak revealed magnetocrystalline anisotropy, which was related to strong low-frequency alternative-current magnetic susceptibility (χ ac ) and induced an increasing trend in saturation magnetization (Ms) as the thickness and annealing temperature increased.

There was no indication that in the range of 5–15% of limestone content, there is a clear trend linking the amount of limestone to the change in yield stress.

The result revealed that, as the annealed temperature increased, the contact angle showed a decreasing trend.

Furthermore, none of our test materials showed a clear trend towards M1 or M2 polarization.

In contrast, the use of isopropanol as diluting alcohol generated particles which showed a strong trend to increase in size at higher calcination temperatures.

The results revealed a decreasing trend in tensile strength with increasing CWP content.

Thus, from a macroscopic point of view, the flow stress of the composite still showed an increasing trend with increasing deformation.

It should be noted that this conclusion is dependent on the problem under consideration, and the differences between the obtained results may be significant in some cases [ 14 ].

The solubility of both drugs was determined as a function of temperature (293.15 to 313.15 K) and IL composition, following an increasing trend with the increase in both conditions.

However, the expansion ratio showed an increasing trend, with the increase in ram speed from 7 mm/s to 11 mm/s.

It is observed that CoF shows an increasing trend on increasing the load from 20N to 60N.