Excerpts

When the concentration of the AgNW solution was 1 mg/mL, the haze value presented an increasing trend with the increase in spin speed, which might be related to the uniformity of the distribution of AgNWs on the substrate.

When the concentrations of the AgNW solution were 2 and 3 mg/mL, the haze value presented a decreasing trend with the increase in spin speed, which might be related to the density of AgNWs on the substrate.

As shown in Figure 6 a,b, with an increasing sp 2 /( sp 2 + sp 3 ) ratio, E a and T 0 show an increasing trend, and σ 300 and T c show a decreasing trend.

Evaluation and Discussion of Barkhausen Noise Test Magnetic parameters do not show a clear trend.

The meta-analysis revealed an overall trend in reduction PD in periodontitis patients receiving melatonin, although the overall difference was not statistically significant ( Figure 2 ).

There is a clear trend in the effect of head angle on the extent of the rock failure zone.

The dual-purpose effect of the BCFC protects the wearer from others and also protects others from an infected wearer, which is extremely significant given the high number of asymptomatic COVID-19 people who are unaware that they are shedding the virus and contributing to the community spread.

However, the fatigue life presented a decreasing trend at the feed rate f = 0.20 mm/rev.

It was seen that the fatigue life had an increasing trend with the surface residual stress S 33 increasing at feed rates of f = 0.10 mm/rev and f = 0.15 mm/rev.

Statistical testing has indicated that there is a highly significant difference between platelet surface coverage on bare and MEG-OH-modified steel.

The size distribution graphs showed a decreasing trend in the mean diameter of composite nanofibers with the increase in GO-COOH content, from 141.40 nm for CS/PG 0.1% to 119.88 nm for CS/PG 0.5%.

Then, keeping the continued incorporation of Gr would not be quite significant to the TS reduction and high-temperature properties improvement of asphalt binders.

The total porosity showed a trend of declining continuously.

For the interleaved laminates, both of the G IC and G IR values exhibit an increasing trend followed by decreasing with the rising of areal densities of TPPI veils.

Under the same fiber length, the fiber content corresponding to the position where the maximum stiffness appeared basically showed a decreasing trend.

The corrosion rate is almost insignificant (×10 −5 ) since its measure is grams over mm 2 and week.

Porosity of the FFF printed coupons reduced but the authors did not find a significant trend in the strengthening of coupons.

When the load was higher than 30 N with a sliding speed of 2.75 m/s, there was an increasing trend in the wear rates for all the samples.

For the immersed HDMC, with the increase of W/B ratio from 0.14 to 0.20 the first-crack strength and ultimate flexural strength show a decreasing trend; however, the ductility index and toughness index show an upward trend on the whole except when the W/B ratio is 0.18.

For all the moisture concentration values considered, the natural frequency values showed an increasing trend with an increase in the skew angle.

For both SSSS and CCCC boundary conditions, the natural frequency follows a decreasing trend with increasing temperature values.

However, its contribution in some cases may be significant [ 60 ]. 4.4.

Since the Fe/Mn ratio of all NR-C samples is higher compared to the S-C samples ( Table 2 ), a clear trend of inhibited Mn precipitation or increased Mn in solid solution can be assumed. 3.2.

BET-specific surface area of the aerogel as AP–RD/GO content showed a trend of increase.

The characterization of the chitosan/Laponite RD/GO composite aerogel showed that the specific surface area and pore volume of aerogel demonstrated an increasing trend with the increase of Laponite RD/GO content, reaching the maximum at 20%, and the average pore size remained basically unchanged.