As depicted, with the increase in HGM content, the thermal conductivity of the composite material shows a decreasing trend.
← all phrases
“a decreasing trend”
Sighted at
p=0.09
In the literature
However, we observed a decreasing trend in the time interval for reaching the maximum instantaneous current and the transferred charge ( Qc ) during one movement cycle with increasing vibration frequency, as depicted in Figure 4 b.
A decreasing trend in hospitalizations due to the extension of HPV vaccination to male subjects is expected in the coming years.
The friction coefficient of the boronized alloy (0.48~0.61) is lower than that of the unboronized alloy (0.86), and the friction coefficient shows a decreasing trend.
When the sintering temperature increases, the ε r and tan δ display a decreasing trend, obtaining values of 920.03 and 0.0452 at T sin = 1180 °C, respectively.
When 0.5% Al is added to the alloy, the strength and plasticity show a decreasing trend, while the UTS and YS are 365 MPa and 325 MPa, respectively.
However, more recent studies have identified a decreasing trend in the use of off-label rhBMP2 usage.
As for the fitting results, generally speaking, with the increase in the aggregate replacement rate of the BBA of RAC, the corresponding recycled concrete cube compressive strength showed a decreasing trend.
It can be seen from Figure 1 a that with the gradual increase of 1250 mesh in CaCO 3 content, the tensile strength and elongation at the break of the films show a decreasing trend.
There were no statistically significant differences in the other TLRs; however, TLR1 , TLR2 , TLR5 , TLR6 , TLR7 , and TLR8 expression showed an increasing trend, whereas TLR9 expression showed a decreasing trend ( Figure 1 ).
showed a decreasing trend in survival and reproduction, but not significantly.
The maintenance sessions were also highly varied ( M = 1.84; SD = 0.75; Range 1.11–2.06), had high overlap in OTR rates with the intervention sessions ( PND = 0%), yielded a decreasing trend.
From the results, it can be found that the tensile strength of the UHPC matrix will show a decreasing trend with the decrease in cement content.
When the catalyst amount was doubled (samples PLA ROP L C and PLA ROP NL C), the [η] had a decreasing trend, but the difference was too small to consider it significant.
However, when the alumina content exceeds this threshold, the excessive filler content leads to particle aggregation in the polymer matrix, which affects the overall performance of the composite material, resulting in a decreasing trend in compressive strength. 4.
After the exposure to Cd, the alpha diversity indexes Chao1 and Ace showed a decreasing trend ( Figure 2 A,B).
A decreasing trend in the storage modulus subsequently occurs with continued thermal exposure, with the storage modulus of PA11_14C reduced to a level below that of PA11_0C.
On the basis of the calculations derived from the NETZSCH software, the enthalpy change (Δ H ) values exhibited a decreasing trend, 0.87 J/g for PAN@BMMs-I-0.05, 0.50 J/g for PAN@BMMs-I-0.1, and 0.13 J/g for PAN@BMMs-I-1, along with an increasing AN content in the P(NIPAM-co-AA) matrix.
However, it should be noted that the fluorescence intensity of the composite substrate reached a large value when grafting time was 3 h and then showed a decreasing trend with a further increase in grafting time.
In the post-PCV7 era, overall incidence had a decreasing trend but was non-significant (−0.03 95% CI: −0.09–0.02, p -value = 0.2334) ( Figure 3 ).
The range of the bearing area at the second column shows a decreasing trend, and the contact load increases in the part of the bearing area close to the maximum contact load, while it decreases in the part of the bearing area away from the maximum contact load.
In general, Ct values increased over time, which indicated a decreasing trend in virus concentration; however, DNA of ASFv was still detected in both spleen and bone marrow samples on day 28.
At 1, 3, and 6 months, the mean number of UUI episodes showed a decreasing trend, but this was not statistically significant ( Table 3 ).
In particular, the color, whiteness, and translucency differences found were higher after one heating cycle and followed a decreasing trend as the number of heating cycles increased.
A decreasing trend was observed prior to the 5.5 km distance; however, after 5.5 km, the THg concentrations at sites S4 and S5 significantly increased.