“a decreasing trend”

The electrical conductivity of the alloy exhibits a decreasing trend with increasing ECAP passes.

In their work, trypan blue and PI staining consistently demonstrated a decreasing trend in DC viability from day 1 to day 5, with viability remaining above 65–70% on the fifth day of culture, thereby confirming that such complementary techniques can also be effectively applied to assess the cytotoxicity of magnetic nanoparticles.

After a 40 d drying and wetting cycle, the gray level of the surface began to show a decreasing trend, which was attributable to the continuous filling of the pores until the products expanded and caused cracks in the specimen.

As the temperature increases, the lattice thermal conductivity of all samples shows a decreasing trend, which is consistent with the typical characteristics of lattice thermal conductivity dominated by Umklapp scattering.

As expected, the elastic modulus exhibits a decreasing trend as the target porosity increases.

Fresh weight also exhibited a decreasing trend with increasing ABA concentrations, with the fresh weight of Col reaching its lowest value (0.005 g) at 120 μM ABA ( Figure 3 c,d).

Concurrently, due to energy dispersion within the enlarged interaction area, the weld penetration depth exhibits a decreasing trend.

As a result, the samples displayed a decreasing trend in strength with an increasing H 2 O 2 content, reaching a minimum at 3%.

Similar values with a decreasing trend over the analyzed periods were observed for abnormal CT lung scans, which correspond to the diagnosis of pneumonia in 24% and 19% of patients, respectively.

[ 13 ] studied the effect of arc energy on the microstructure evolution of alloys fabricated by cold metal transfer-wire arc additive manufacturing (CMT-WAAM) and found that the ferrite content showed a decreasing trend with the increase in arc energy.

From Figure 8 , it is evident that as the tension fluctuation coefficient increases, the area of the amorphous peak slightly decreases, indicating that with a draw tension of 65 cN, the increase in tension fluctuation leads to a decreasing trend in fiber crystallinity. 3.4.

They observed that residual stress exceeding the yield strength was generated on the upper surface of the welded joint, and both residual stress and hardness showed a decreasing trend with the increase in heat input.

MDA levels showed a decreasing trend with an increasing PSH concentration.

A decreasing trend of hardness along the depth can be observed due to the decrease in temperature and less martensite in the SZ.

However, as the CO 2 content in the gas mixture increased, the apparent activation energy of the reaction presented a decreasing trend.

For co-continuous EABC systems (EABC43–EABC45), tensile strength and toughness increase progressively with ER concentration, while elongation at break exhibits a decreasing trend.

Both the surface CRS and its affected depth exhibit a decreasing trend with increasing pulse width.

For the multilayered models, the plastic flow stresses largely follow a decreasing trend from L650/750 to L600/800 and then L400/1000.

Interactions of the main factors were not significant for most nutrients; with regard to SP as a factor, a decreasing trend from SP1 to SP3 was observed for P, K, and Fe concentrations ( Table 4 ). ‘Buža puntoža’ exhibited the highest P levels, compared to all the other genotypes ( Table 4 ).

In contrast, almost all varieties showed a decreasing trend in total spikelet number per panicle at 19.0 °C, whereas the extremely strong and strong varieties remained almost unchanged at 18.5 °C, and the moderate and weak varieties showed a reverse increasing trend at 18.5 °C ( Figure 4 a, Table S1 ).

Likewise, the corn cereal group demonstrated a decreasing trend in GQ values from baseline (85.39 ± 11.98) to post-intervention (78.26 ± 12.42), although this difference did not reach statistical significance ( p = 0.060).

Fasting glucose and HbA1c levels showed a decreasing trend in both groups, although the changes were moderate.

A decreasing trend in these ratios during storage indicates oxidative degradation of the UFA [ 41 ].

In contrast, C 4 + selectivity showed a decreasing trend with rising temperature up to 290 °C, then stabilized and remained nearly constant at higher temperatures.

When the amount of oxidized graphene added is increased to 0.1%, the improvement ratio of cohesion shows a decreasing trend. 3.6.