Excerpts

On the other hand, topography of La oxide coatings did not shown a clear trend in the R a values with the deposition parameters ( Table 1 ) .

Specifically, for f = 0.10 mm/r, h p showed an increasing trend with v c ( Figure 11 ).

The data reveal that the yield stress and compressive strength of the specimens both present an increasing trend as the strain rate increases.

The relationship between sliding speed and S/N ratio in Figure 3 shows a decreasing trend for speeds from 1 m/s to 3 m/s.

As an overall trend, the PS-GPs, which used the GP-liquor #1SW, gave good results of the immobilization ratios of Sr 2+ and Cs + .

There is also a decreasing trend related to the cutting speed that plateaus in a horizontal line.

Cross sections for ionization events are several orders of magnitude higher than those for the knock-on damage, with an increasing trend towards lower electron energies due to increasing interaction between the impinging electrons and electrons in the sample.

A slight anisotropy can be noticed for Ti–6Al–4V, consisting of a decreasing trend of strength from the X- towards the Y-orientation.

It is also an important trend in the field of textile printing and dyeing research in the future.

The modeling results for the surface area evaluations of the samples showed an increasing trend, i.e., the surface area of the RSKCuIv4 was the smallest surface area of investigated samples, followed by the surface area of the CerexCuIv4, and by RSKCu+Ni.

For higher temperatures, oxidation may be significant [ 38 ], and this is why the oven baking process was conducted up to 350 °C, and not in higher temperatures.

(3) The change character of S parameter in candidate steels with increasing irradiation doses was not obvious as the Fe + showed a trend towards a clear saturation.

Therefore, as the ratio of TEOS increased, the stability of silica/MMT showed a decreasing trend.

The thermal expansion coefficient α is both theoretically and practically significant and is essential for the thermodynamic equation of state.

All four of these plots show a clear trend: the d F / d T and d μ / d T sensitivities increased progressively as the average temperature and absolute humidity fell, and with good consistency between the results for the two sections of the G5 string (green and lime).

Furthermore, musicians are finely-tuned to small details of the behaviour of their instruments, so that quite subtle aspects of the string behaviour may be significant.

The current density has an increasing trend as the applied anodic voltage increases.

Using the voltage and the hot and cold side temperatures to calculate instantaneous value of Seebeck coefficient reveals an interesting trend of the Seebeck coefficient for both transient and steady state conditions.

Furthermore, the presence of the PPPh leads to some improvement of the properties, especially with concern to the elastic modulus and the elongation at break, where such enhancements are quite significant.

The total number as well as the size of pores presented a decreasing trend.

The yield stress and viscosity of neat OWC slurries had a decreasing trend with the increase of WCRs.

Similarly, only the yield stress of OWC composites added with CNCs obtained by the BPM and MBM models had an obvious trend, increasing with the increase of the CNC addition amount ranging from 0.05% to 0.20%.

The ME coefficient shows a decreasing trend under a low stress and the curve shifts to the left overall with an increase in magnetic field.

Particularly, often they are mentioned together with NIRF (Near Infrared Fluorescence) using the dye Cy5.5 (Cyanine 5.5)-SPION system [ 45 ], but also CT (Computed Tomography), PET (Positron Emission Tomography), and SPECT (Single Photon Emission Tomography) are possible to be used in combination with MRI when applying SPIONs as a multimodal contrast [ 46 ] Finally, there is an increasing trend to use SPIONs in diagnostic and clinical techniques.

After 250 cycles, the Rct and W of the Cel-CS showed an increasing trend to a smaller extent, while that of Cu-CS showed an obvious increase, implying better structure stability of the Cel-CS electrode.