Excerpts

With the increase in the load level, the difference of positive displacements between the two sides of the pre-notch shows an increasing trend.

The μ ′ values of Fe 3 O 4 exhibit a decreasing trend from 1.28 to 0.88 at 2–8 GHz and remain constant with slight fluctuations over 8–18 GHz.

The depth of the surface metamorphic layer exhibited a decreasing trend with some fluctuation with the increment of the tool rake angle (as shown in Figure 8 c).

The depth of the surface metamorphic layer exhibited an increasing trend with the increment of the tool rounded edge diameter.

In terms of the control group samples, the dynamic stability values presented an increasing trend with an increasing RAP content.

As a result of esthetic reasons, there is an increasing trend to substitute titanium abutments with all-ceramic materials, i.e., alumina (Al 2 O 3 ) and zirconia (ZrO 2 ), to avoid peri-implant soft tissue discoloration in patients with a thin gingival biotype [ 5 ].

(3) Emulsified asphalt content It can be seen from Figure 11 that as the content of emulsified asphalt continued to increase, the fracture energy of the mixture showed an increasing trend.

Although with the less ductile post-peak softening response of pure fibre reinforced to conventional reinforcements, the contribution of the fibres in AAC beams to post crack ductility could be considered significant, as an unreinforced AAC beam would have failed with brittle failure after first crack [ 13 ].

Then, it exhibited a decreasing trend over 72 h of measurement.

The LR, from Figure 4 b, is highly sensitive to the morphology variation of 1L-ST and 2L-ST and shows a decreasing trend with an increasing SH frequency.

Over time, the number of published papers per year shows an increasing trend ( Figure 3 a).

As in the case of II-Zn/Fe (but different compared to I-Zn), the cyclic voltammogram is typical of an alloy that is passivated, the cathodic branch is located below the anodic branch and the distance between them is very large (passivation is quite significant).

Temperature did not affect the alkanes, whereas alcohols showed a decrease with an increasing trend.

Additionally, the 8 M samples showed an increasing trend with the increase of molarity, while the 12 M samples showed a somehow constant change, suggesting that almost all 12 M samples exhibited higher voids and pores.

The total temperature of the supersonic gas jet remains stable near the outlet of the Laval tube and then exhibits an increasing trend.

With the increase of the graphene doping amount, the bulk density of SiC ceramics showed a trend of gradual decrease.

The room temperature magnetic properties exhibited that Co doped GNMSs are ferromagnetic in nature and an increasing trend in magnetism was observed with increasing Co contents.

A particular source of variation may be significant if the calculated F value at a certain confidence level is greater than the tabulated F value at the same confidence level.

An increasing trend in the size of the deformation zone by up to four times its original pore size is reported at a higher feed rate and lower cutting speed [ 18 ].

However, many other parameters, like temperature, pH, potential difference and impurities are highly significant.

The elongation at break, which is an indicator of material flexibility, followed a decreasing trend with increasing loads of CNF.

With the developments in digital image acquisition and image processing techniques, the quantification of structural features, 3D model rebuilding together with the finite element (FE) mesh generation is considered to be a significant trend of current Micro-CT research.

In C75 concrete there is also a pronounced initial evolution, but with an increasing trend until 72 h and with much higher values, at least 45% at 24 h and 80% at 72 h, comparatively with the other concretes.

After the coupling of 90 days, elastic modulus of the bars showed a decreasing trend with the increase of the cyclic loading.

For the three cement compositions including both ACC and vaterite, the results show a clear trend: higher initial vaterite concentration leads to faster growth rates and a faster recrystallization process.