Excerpts

We observed an increasing trend for the density and compressive strength of the mortar as the collection depth of the sample increased.

αHH significantly hardens at an early age, and after reaching maximum strength, the strength shows minimal change or a decreasing trend; this has been verified in previous studies [ 15 , 16 ].

As a result, the hole profile becomes increasingly steeper, and the hole taper shows a decreasing trend with respect to the laser power within the selected range.

Such an increasing trend is not a rare phenomenon, such as the Pb 0.94 La 0.04 [(Zr 0.7 Sn 0.3 ) 0.9 Ti 0.1 ]O 3 ceramics prepared by the solid-state reaction method reported by Xu et al., where apparent exponential elevation of the energy-storage density is observed above 60 kV/cm [ 19 ].

For the studied lithotypes, there is a clear trend observed within all three test methods to evaluate the efficiency.

However, a clear trend and prediction for higher concentrations like 25 wt% can be drawn. 2.2.2.

The introduction of boric anhydride creates a moderately significant impact on the strength of the engineered cementitious composites.

However, due to the functions of internal autoclaving, secondary hydration of unhydrated clinkers and SCMs, and the pozzolanic effect, the post-fire strength of concrete may have an increasing trend before 300 °C [ 43 , 44 , 45 ], especially for the concrete made with siliceous aggregates [ 43 ].

Even though the bending strengths were comparable in all three attempts, considering standard deviations, there were partially significant differences regarding laminate thickness and maximum bending force ( Figure 3 d).

However, at higher compositions, x = 0.08 and 0.10, a decreasing trend has been observed, which shows the reluctance in the mixing of V ions.

As shown in Table 2 , with an increasing LDH dose, the TTI of asphalt binders shows an increasing trend, whereas the THR gradually decreases.

Accordingly, the SD of charge quantity also showed an increasing trend as surface roughness increased.

E values and H values for the secondary cell wall ( Figure 8 ) both showed an increasing trend from the inner to the outer parts of the wood disc, but a significant reduction was shown from S2 to S1.

At a dosage of 0.41, expansion showed an increasing trend with respect to the reference sample during the first 28d which indicated that the lower the concentration of Li + , the faster the reaction in the early stage.

In conclusion, chondrocytes and fluid cartilage may be an interesting and possibly significant source of autologous tissue, which is ready to be utilised in therapeutic procedures, such as the regeneration or repair of nose tissue defects and irregularities of the nose.

However, the fracture zone shows an increasing trend with the increase in clearance and, therefore, even at 250 °C, the fracture zone value is observed to increase from approximately 0.043 mm at 10% clearance to approximately 0.11 mm at 30% clearance.

Conversely, the porosity of blended mortars presented a decreasing trend with the increasing of cement content, especially for CS-SAC blended mortars, as shown in Figure 4 .

However, with the prolongation of the mineralization time, the conductivity showed a trend of increasing sharply first and then, more gradually, see Supporting Information, Figure S7 .

A clear trend was not observed for the average or the maximum diameters as the CNT content was increased.

It was also found that the influences of the geometry and size of GPL nanofillers are quite significant but limited when the b GPL / t GPL of GPLs is higher than 10 3 .

The computed stepwise regression analysis for Cr sorption showed the highly significant influence of ash content and BET surface area.

In recent years, laser welding has gradually come into use for pipeline steel welding, so it is extremely significant to study the effects of changing laser parameters on the microstructure and properties of welded joints.

According to their study, entrance circularity showed an increasing trend with the laser power, but decreased with an increment in hole diameter, while larger hole diameters or laser power led to increased exit circularity.

The expression levels of the genes coding for the contractile proteins, such as Troponin T ( TNNT2 ), myosin binding protein C ( MYBPC ), and cardiac alpha actinin ( ACTN2 ) had an increasing trend after the 11 days of culturing on both the PET 5 and control hiPS-CMs.

While there is a little difference in the Z real in two opposite stepping directions, the difference of Z img values in cathodic potential stepping followed immediately after the opposite direction potentiostatic experiments, showed an increasing trend with decreasing the frequency.